Blog / All mounting points ready to get welded and new bearing house

E-Streetquad All mounting points ready to get welded and new bearing house

All mounting points ready to get welded and new bearing house

Posted on 17 July 2014 at 12:05 am (CET)
Category: General
Posted on 17 July 2014 at 12:05 am (CET)
Category: General

The less good news first. I wanted to remove the bearings and axle from the bearing house so I can soon place much better bearings of the brand SKF in here instead of the Chinese bearings. This just didn't go so well on one side, a piece of the bearing house broke off and there's a small crack as well. So I can't use this one anymore.

E-Streetquad All mounting points ready to get welded and new bearing house


But I did get everything out so at least I know how everything fits together now.

E-Streetquad All mounting points ready to get welded and new bearing house


Here's one reason already why I don't want to use these Chinese bearings. Just look at the difference between the 2 bearings, the one on the left has no grease at all in there while these are still new closed bearings. But they're bad quality anyway, these bearings break very quickly. Especially that one without any grease.

E-Streetquad All mounting points ready to get welded and new bearing house


Meanwhile I already got a new bearing house. There were also bearings in this already but everything went well removing them this time.

E-Streetquad All mounting points ready to get welded and new bearing house


And then the good news. All mounting points for on the frame and the battery boxes are finally done. Was quite a bit of work, especially since I had to make these to size using only a bench vice, hammer and file. But they can all hopefully get welded within a few days now.

E-Streetquad All mounting points ready to get welded and new bearing house


The ones for the smallest battery box up front were the hardest because they needed a few corners and a part that's skewed. But they turned out pretty good, definately strong enough for the 2 batteries that are going in there.

E-Streetquad All mounting points ready to get welded and new bearing house


E-Streetquad All mounting points ready to get welded and new bearing house


I also made the holes in the front fender already with mounting points for the charge plate. Ofcourse I used rivet nuts for this again.

E-Streetquad All mounting points ready to get welded and new bearing house


E-Streetquad All mounting points ready to get welded and new bearing house


Hopefully another update soon once everything's welded.