Finished the whole wiring diagram now. Only still have to add the BMS but I can't yet till I actually have it here. No idea how it'll get wired up just yet.

The only thing I'm not sure about is the clutch lever. I want to use this in combination with the forward/reverse switch to be able to drive in reverse. According to the regulations of the RDW (Dutch road safety institute) you need 2 seperate actions for this (or only able to activate below 5 kmh but this will be too complicated I think) so I think this will be the easiest solution. Just don't know if it's possible this way or if I'd be shorting out the controller when the switch is in reverse and the clutch lever isn't pulled. So I'll have to ask around a bit before I actually connect it like this.

As I'm planning to make a new wire harness I already started making a wiring diagram. The 12V part is pretty much done now. Will probably have to add some more to it later on for the controller and BMS but still don't know exactly what.

I think I'll just add the 72V wiring into this as well, at least I have one clear diagram for everything then.

Meanwhile I've also placed an order for the controller, charger, cables and some other small parts at Rebbl, a company that also converts cars to fully electric. If all goes well I should have all of these within 3 weeks.

Today I checked the weight of all parts I've taken out. I wanted to know if the weight would stay equal or maybe a bit heavier. And apparently it will get a bit heavier after all but still nothing to worry about for passing inspection. The weight balance will probably stay around the same I think, still hard to tell.

Weight of original parts (with empty gas tank).

Expected weight of parts after conversion.

I also still changed the layout a bit, one battery that I had placed above the charger I moved to the front. Should fit pretty well there and this way I'll have some more space around the charger for better heat dissipation while charging.

Today I checked the 12V wiring and tested if all the lights and tachometer works.

First I had to remove all tape so it would be easier to see how the wire harness is connected.

Everything worked well, except 2 wires that were switched in a plug but that was easy to fix.

I'm just not that happy with this wire harness since the color codes don't really match with some of the components. It's also soldered together pretty badly and the plugs aren't even waterproof. I'm thinking of just making a complete new wire harness instead of using this one. It's a bit more work again but it'll be worth it in the end.

I finished making all the paper models for the batteries, charger, controller and motor. Was a lot of work but I really think this is the easiest way to measure if it all fits.

It all has to somehow fit in this frame.

This is what I tried first. Since the controller is the biggest part I placed the model for it in the biggest space, where the engine used to be. However I wasn't able to fit quite a few batteries this way and not even the charger. The motor would fit very nicely in the rear swing arm though.

On the second try I did find a way to fit everything. Controller hanging on the rear, charger fits perfectly in the middle and all batteries would fit. But I'm still not completely satisfied with this layout since it will be hard to secure the real parts to the frame this way.

But either way I will have to remove some of the mounting points and the battery tray off the frame that are in the way. I won't be needing them anymore anyway. So that's what I'll be doing next.