Nederlands
Blog / Started with battery box #1
Today I was finally able to start making the battery boxes. Here are the definitive drawings of how I'll be making them. With 4 battery boxes, should all fit nicely. Just still have to see where to place the sensor plate for the display and the fuse with fuse holder. Will probably be as close as possible to the emergency switch so I can keep the cables short.
I started with the biggest box. It'll be the most difficult so I just want to get it done and over with. Here are the plates, nicely tailor-made with my table saw. Only the back plate (as it'll be in the frame) and cover are slightly bigger so I have some play. This will be evened out later on.
I glued two of the plates now, will have to wait untill this is hardened.
Tomorrow I'll continue with the other 2 plates. I just still need to make holes on one side for the cable glands.